![]() ![]() The motors shown in the photograph at the top are 1104 ones and the holes are for M2, but be careful with the length of your screws so you don't destroy the motor windings! Bill of Materials (BOM) Brushless Motors and Propellers The central was designed with 20x20mm mounting holes. ![]() In the case of bamboo, because they break much more easily than carbon fiber (never managed to break any!), if you glue them it will be annoying to replace.Īll the parts in red are made of flexible TPU 95A.įlight controller and ESC (4-in-1) are mounted between the battery and the central part of the frame (the empty space seeing above). If you get a nice snug-fit between the struts and the TPU parts, you will not need to glue them together. In this case, you will need to glue the struts (carbon fiber or bamboo skewers) or, instead of absorbing the impact, the frame will just fall apart and almost no impact energy will be absorbed by the flexible parts. some holes will change the internal diameter and they may be too loose. Depending on your printer, settings, fillament, etc. The only part that needs support to be printed is the Battery_holder_magnetic_lid.stl. It's a very snug fit! You need to squeeze the round tube-like side, but without damaging it. 3D files (STL) for printing and assembling current and past versions of CogniFly ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |